Network card settings
~~~~~~~~~~~~~~~~~~~~~

::

    ┌────────────────────────────────────────────────────────────────────────────┐
    │              Network Settings on node1 (Version 2.0.X build XXXX)          │
    └────────────────────────────────────────────────────────────────────────────┘

    ┌─┬──────────────────────────────────────────────────────────────────────────┐
    │1│View link status on all network cards                                     │
    │2│Add network card settings                                                 │
    │3│Remove network card settings                                              │
    │4│Configure LACP (bond)                                                     │
    └─┴──────────────────────────────────────────────────────────────────────────┘

    Move the cursor or enter a it's corresponding number (Q to Quit)              

    Main> System Settings> Network> NIC> 

View link status on all network cards
#####################################

::

    Status of all network cards

    eth0: autonegation on, 1000Mb/s, duplex Full, link ok
    eth1: autonegation on, 1000Mb/s, duplex Full, link ok

    Press any key to continue

Add network card settings
#########################

::

    Add network card settings

    eth0: Set speed to? (10/100/1000/auto or Q to quit) <1000>: auto
    eth1: Set speed to? (10/100/1000/auto or Q to quit) <1000>: auto

    Write the above configuration to disk? (<Y>/n): y
    Activate the new network settings? (<Y>/n): y

    Press any key to continue

Remove network card settings
############################

::

    Remove network card settings

    Remove persistent network card settings? (<Y>/n): y

    Press any key to continue

Configure LACP (bond)
#####################